Confer Plastics 8000X, Руководство по сборке, установке и использованию

Страница: 4 / 6

Step 11.
Mounting blocks
Step 7.
Push the
adjustable tubes
with mounting
blocks into
handrails.
Step 8.
Attach the handrails to
the ladder assembly,
making certain that the
treads face correctly.
Note: Coat the ends
of the stringers with
liquid soap or spray
lubricant before
sliding handrails
into postion.
Step 9.
Attach the shield by
sliding the shield
opening over the top
of each handrail.
Push down into
position and rotate
90° outward as
appears in step 10.
Note: Carefully
spread open
shield to slide
over handrail.
Step 10.
DO NOT PLACE THE STEP-1X
INTO THE POOL AT THIS TIME
Slide the shields down over the
upper handrail posts on the
Step-1X until the mounting blocks
rest on the top step of the Step-1X
as shown in the diagram. Using a
cordless drill attach the mounting
blocks to the top step using
4 - #10 x 1-1/4” screws in each
mounting block. (8 total).
Separate the 8000X from the
Step-1X by lifting the ladder off
of the adjustable tubes. Do not
remove adjustable tubes and
mounting blocks
from the Step-1X.
Remove the
Confer Step
handrails so
shields can
be slid over
the handrail
posts.
Handrail posts
Shield
WARNING! Verify that your chosen location is level,
has a solid base, and will be in full view of competent
adult supervision when in use.
WARNING! Shields must be attached
to reduce the risk of entrapment
WARNING! Using a corded drill near
pool may result in electrocution.
At this time with
ADDITIONAL
help place the
Step-1X into swimming pool, refer to separate
Step-1X instructions.
With the Step-1X in position install the 8000X ladder by
sliding the shields down over the step handrail posts
and the ladder rails down over the adjustable tubes.
Attach the ladder handrails to the outside ladder
stringers using two #10 x 1-1/4” screws at the
pre-marked locations on each handrail. (4 total)
Level the ladder platform by moving up or down on
the adjustable tubes. Once level secure the ladder
handrails to the adjustable tubes using two
#10 x 1-1/4” screws at the pre-marked locations on
each ladder handrail. (4 total).
Fasten the shields to the 8000X handrails using four
#10 x 1-1/4” screws per shield. (8 total)
Install the Step-1X handrails, refer to separate
Step-1X instructions.
WARNING! Pool
ladder must be
attached to
Confer-Step-1X
platform for
stability.
Using a cordless
drill, secure the
8000X mounting
blocks to Confer
Step top step
before securing
the 8000X
handrail.