Conel CLEAR SOFT TWIN, Руководство по эксплуатации

Страница: 88 / 140

88
10.5
SCOPE OF SUPPLY
/ Water softener
/ Salt container
/ Built-in rotary flange 1¼" with bayonet fixture and screw connection 1"
/ Safety overflow hose and wastewater hose
/ Trap with top piece
/ Wall support
/ Console set
/ Operating instructions
/ Hardness measuring equipment JGHP 0 - 30 °dH (order no. 8742120)
Please check the consignment immediately after unpacking for completeness and transport damage, as
later complaints can not be accepted.
10.6
ACCESSORIES
/ Bypass valve JQX (order no. 8735210)
/ QUICKSET extension JQR for series connection of two devices (e.g. filter and water softener) to one
pipe connection (order no. 8250041)
/ Wall bracket for salt container (order no. 8733066)
/ Failure signal cable (order no. 2200717)
/ CLEAR BOX (available at a later date)
10.6.1
PROTECTIVE MEASURES AGAINST CORROSION
If water has a water hardness of 0 °dH plastic pipes or corrosion resistant pipes should be laid.
In the case of water with partial softening (approx. 8 °dH), zinced pipes and copper pipes can be laid.
Our recommendation:
Install a CLEAR DOS metering pump in the mixed water pipe downstream of the water softener, in order
to proportionately enrich the water with a mineral solution.
The JUL mineral solutions contain active components, which stabilise the residual carbonate constituents
and create the prerequisites for developing a homogeneous protective layer in downstream pipe systems.
These active ingredient components correspond to the prescribed type, quality and quantity in the current
German drinking water regulations (treatment substances and disinfection methods).