Condari QASAIR CON, Инструкция по установке и эксплуатации

Страница: 8 / 60

Qasair Rangehoods Installation Instructions
8
INSTALLATION INSTRUCTIONS
• MT
• MC
1. Fit a shelf at 410mm from the base of the cupboard.
2. Note hinge location prior to drilling.
3. Work from the centre line mark and drill 4 x M5 to M8 holes.
4. For top ducted models, cut out hole for the ducting allow 20mm clearance.
5. Fix left and right hand mounting brackets (supplied) 145mm from the base of the cupboard flush with the rear
of the unit. Notch to the back.
6. Lift rangehood onto mounting brackets by holding either end. DO NOT use the slide mechanism as this may
cause damage.
7. Insert the 4 x 50mm pan head screws supplied through the shelf and into the rangehood. Turn clockwise to level
the rangehood.
8. Fix the rangehood position by inserting 2 x no 8 1/2 inch screws through the left and right hand brackets.
9. Fit doors.
10. Minor adjustments may be required on the rangehood handle. Loosen the screws on the rear of the handle and
adjust handle position and re- tighten. The rangehood handle can be replaced.
11. All of the rangehoods shown on pages 1 and 8 are supplied with a 10AMP plug and lead for connection
to a 10AMP GPO, which must be in an accessible position.
12. The handle can be removed and replaced with one made by the cabinet maker to fit in with the kitchen cabinets.
The MT 90 has 3 screws and the MT 60 has 2 screws. These can be accessed by sliding the facia out and
un-screwing the front from underneath and behind the facia. The handle will come off by tilting it forward from
the top.
Installation must be carried out by the procedure outlined.
Failure to do so may void the guarantee.
Electrical:
Wiring to the appliance must comply with State and local Regulations.
Connection to be carried out by a registered electrician.