Condari QASAIR 4F, Инструкция по установке и эксплуатации

Страница: 6 / 56

Qasair Rangehoods Installation Instructions
6
INSTALLATION INSTRUCTIONS
• 4F
• PRE / FRA
• MA
• SQ 420 / MOL
• FPR
• BUR / BEL
• D 400 / D 500 / SEN
It is recommended that the rangehood be mounted 100mm back from the edge of the benchtop.
1. The rangehood can be installed between 700mm and 800mm above the cooking surface. The installer should
check for local requirements in case additional provisions apply.
2. It is advisable to remove fans for easier handling of unit by removing retaining bolts or clips and unplugging
electrical connector.
3. Measure hole centres and duct size on top of the rangehood. This will vary with the hood size, model and
number of fans fitted and will determine the ducting required.
4. Using a plumb line, mark the ceiling before making the cut out. Check for obstructions like electrical cables etc.
5. Cut two (2) supporting beams approximately 1.0m long and pre-drill hole centres so that the supporting beams
are 90 degrees to the ceiling joists.
6. Fit 8mm all thread (threaded rod) through holes provided and secure with nuts and washers.
7. Level unit by tensioning the 8mm nuts. Do not over tighten.
8. Fit off ducting as required.
Installation Suggestions
1) 2)