Condari CONDARY CON 60L Скачать руководство пользователя страница 4

Страница: 4 / 44

Qasair Rangehoods Installation Instructions

The installation of Qasair Rangehoods must comply with the information in this booklet. Qasair Rangehoods are

designed and made to work efficiently over all domestic cookware available on the Australian market.

It is necessary to allow electrical disconnection of the rangehood after installation.

This may be achieved by either.

a) Installing a power point to an accessible area for the rangehood.

b) Incorporating a wall switch to the fixed wiring that supplies the rangehood.

Clearance from cooktop to Rangehood

For electric hot plate cooktops

Please follow the manufacturers instructions / recommendations.

For Induction cooktops

Induction cooktops may present problems with condensation on filters of rangehoods.

All Qasair rangehoods installed above an induction cooktop must be installed no less than 750mm between the

induction cooktop and the rangehood, with the exception of the Eastmore (EAS) rangehood which can be installed

no less than 600mm and the Grampian which can be installed no less than 650mm. Undermount (NDCH), Conley

(CON) and Foldaway (FA) rangehoods are

not

suitable for induction cooktops.

For gas cooktops

All Qasair Rangehood installations over a gas appliance must comply with (AS/NZS 5601.1).
The requirements for the installation of Gas Appliances (AS/NZS 5601.1) states that the clearance between

the highest part of the burner of a gas cooking appliance and a Rangehood be no less than 600mm. If the gas

appliance is designed for use without a cooking vessel (as defined by AS/NZS 5601.1), then the clearance from the

cooking surface to the grease filter shall be no less than 1200mm.
The recommendation for Qasair wallmount rangehoods is that they be installed between 700 to 800mm above the

highest part of the burner. When the rangehood is installed in a galley or partially enclosed kitchen the rangehood

can be installed between 900 to 1000mm above the highest part of the burner.
Qasair island rangehoods should not be installed any higher than 800mm above the highest part of the burner as

any movement around the bench will result in fumes being drawn out from the catchment area of the rangehood

with the exception of the Thermidor and Liverpool which for aesthetic reasons is installed flush with the ceiling.

Ducting

For all your ducting requirements please refer to the Qasair Rangehoods Ducting Pieces brochure included
with your Rangehood or please consult our website where it can be viewed or downloaded.

1. Every Qasair rangehood must be ducted to the outside atmosphere by the use of zinc-alume duct or

non-porous and non-flammable materials.

Do not use of any type of flexible ducting or plastic PVC piping

Rangehoods must not be vented into a wall cavity or a ceiling space. Externally ducting the rangehood prevents

a build up of grease, which can be a fire risk. Ensure the external outlet vent does not restrict the airflow in any

way, as this may result in reduced performance.

2. Qasair rangehoods must be ducted in duct work equivalent to the outlet of the rangehood ie: The cross

sectional area of the rangehood outlet and the duct work must be equal. Do not reduce the duct size or have

sharp bends. Enlarge the duct size if the duct is to run 6 metres or longer. Advice from Condari is available to

ensure optimum performance. Always use non-flammable materials to minimise the risk of fire in the duct.

3. Ensure all ducting pieces are correctly fitted and sealed with either duct tape or silicone to ensure that fumes

do not escape into the ceiling space and seep into living areas through vents or light fittings.