Condair RH 1.8, Инструкция по установке и эксплуатации

Страница: 48 / 68

48 Maintenance
7.2 Maintenance intervals
To maintain operational safety, the Condair RH steam humidifier should be serviced once a year (e.g.
before the humidification season).
Note: The Condair RH has a special maintenance counter for replacing the steam cylinder. If the service
life of the steam cylinder is about to expire, the yellow cylinder status LED and the yellow fault LED
alert you that the steam cylinder needs to be replaced. If the steam cylinder is not replaced before the
maintenance counter has elapsed (approx. 3 weeks), the Condair RH is stopped and the cylinder status
LED and the fault LED light up red.
7.3 Maintenance list for annual maintenance
Below you will find an overview of the work to be carried out during the annual maintenance of the
Condair RH steam humidifier.
Components Work to be done
Steam cylinder Replace as soon as the cylinder status LED and the fault LED
light up yellow.
Drain valve Remove, disassemble and clean, replace if necessary.
Inlet valve Remove and clean filter insert, replace if necessary.
Fill cup Inspect, clean if necessary.
Drain pan Inspect, clean if necessary.
Drain pipe and siphon Inspect, clean if necessary (decalcify and rinse out).
Steam installation Inspect steam and condensate hoses for cracks and ensure that
they are correctly attached, replace defective hoses.
Water installation Inspect water hoses in the unit for cracks and to see that they
are correctly attached, replace defective hoses.
Check supply pipe is tight, tighten it if necessary. Clean water
filter, if available.
Electrical installation Have all cables in the unit checked by an electrician that they
are correctly fixed and that the insulation is not damaged