Copyright
®
2007 by Conceptronic – All rights reserved
www.conceptronic.net
Page 5 of 6
2.6
As soon as the upgrade process is completed, the screen will go black.
Note:
The device is still turned on. You need to manually turn off the device by pressing the
‘
POWER
’ button on the remote control. You can completely turn the device off by
turning off the switch on the back side of the device.
2.7
Remove the USB stick or memory card from the device.
Note:
Never do this when the device is turned on and the upgrade process is busy. This will
result in an unusable product.
3.
Checking the firmware version
3.1
Make sure the CSM3PL is connected to a TV or monitor.
3.2
Select a folder by using the navigation buttons on the remote control.
3.3
Press the ‘
FUNC
’ button on the remote control, select ‘
PROPERTIES
’ and press the ‘
Enter
’
button.
3.4
Now press the ‘
Pause
’ button (
II
) five (5) times in a row.
3.5
Leave the current screen by pressing the ‘
FUNC
’ button.
3.6
When the ‘
Fast Forward
’ button (
>>
) is pressed, the current firmware version will be shown.
This must be:
VER 32-O MP07ST011208A-2L
.
3.7
If the version isn’t shown long enough, you need to press the ‘
Fast Forward
’ button again.
3.8
If the displayed version isn’t the same as the version described at point 3.7, then you need to
repeat the upgrade procedure as described in chapter E.
