the TURBO button, you may increase the motor rotation speed to the maximum for a short time. Do not insert
the extension into the processed food or remove it from the food while it is moving.
6. Switch the unit off after mixing. Disconnect the cable from the socket.
7. Release the rod extension by turning it and rinse it immediately under running water (see Cleaning and
Maintenance). Close the rear cover by inserting it.
Stand with rotating bowl
For whipped and mixing with stand and rotating bowl appliance you could not ever hold in your hand.
Place the stand body (8) on a flat work surface.
Unit body (4) attach at the body of stand (8), (you will hear an audible click detent button of whipper (5))
Stand with unit body (4) open by Locking button of stand (7).
Place the accessories selected A or B in the opening of the appliance and pedestal with locking button of stand (7)
to return the appliance body in its original position.
Now you can set the desired speed 1 to 5
After mixing the appliance off. Unplug the power cord and accessories under warm running water immediately
rinse (see paragraph cleaning and maintenance).
CLEANING AND MAINTENANCE
Turn off the unit and disconnect the power cord from the wall outlet before cleaning and after use.
Clean the appliance body with a wet cloth.
Do not use steel wool, abrasive agents or solvents to clean the unit.
Wash the whisks and hooks in tepid water with detergent and rinse in clean water; you may use a dishwasher.
Do not immerse the rod extension into water!
Just wash it. Make sure the water does not enter the extension,
where the driving spindle is. If this happens, leave the rod extension to dry and apply a few drops of vegetable oil
to smoothen the operation of the extension bearings.
TROUBLESHOOTING
Problem
Cause
Solution
The motor is not
running.
The plug is inserted into the socket
incorrectly or insufficiently.
Check the plug connection.
The socket is not receiving electricity.
Check for voltage, e.g. by connecting
a different appliance.
The cover of the rod extension hole is not
properly closed.
Close the cover properly.
The extension rod is not attached
properly.
Check the extension rod attachment.
The motor has stopped
working.
The motor is overloaded, the heat fuse
has been activated.
Disconnect the power supply cable
from the socket.
Check and clear the air
passage at the inlet/outlet grills.
Let the unit cool.
EN
24
SR3360