Concept2 OPV3660, Руководство пользователя

Страница: 65 / 76

65
OPV3660
EN
Carbon filter (to be purchased)
This filter is only used for the recirculation mode.
The filter contains an active carbon absorbing the smell being discharged. The active carbon will be saturated after
some time, hence the absorption capacity will be shortened. This filter cannot be washed or cleaned in any other way.
When the appliance is in common use, the carbon filter should be replaced every 2-3 months. In case of more frequent
frying or deep frying, shorten this interval.
1. Remove the metal filters as shown in Fig. 1.
2. The carbon filters are situated on both motors. Turn the filters, until they are secured (see Fig. 2).
3. For effective recirculation, take the air duct line through the cabinet upwards so that the filtered air can return back
to the room without any barrier.
4. To replace the carbon filter, proceed in reverse order.
Note:
Air duct not included.
INSTALLATION OF THE APPLIANCE
Caution!
Risk of electric shock! Before installation, disconnect the power cord from the wall outlet. Otherwise there is a risk of
death or electric shock.
• Defects caused by improper installation are not covered by the warranty.
• Installation is the responsibility of the customer not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to incorrect
installation.
•
All guards must be placed firmly in their appropriate place in a way they cannot be removed without using special
tools.
• Install the appliance at least 500 mm over electric cookers or electric cooking plates and at least 500 mm over gas
cookers or gas cooking plates.
• Extracted air should not be led to a chimney intended for discharge of flue gases and combustion products or
a shaft serving for ventilation of rooms where fireplaces are situated.
•
A bend of the ventilation pipe should be ≥120°.
• The room must be well ventilated during cooking.
Fig. 2