EN
27
OPK2160
Removal
Before removal, disconnect the power cable from the wall outlet; follow the reverse steps to remove individual
parts of the unit.
Fig. 4
8. Mount the backflow valve on the output hole,
and connect the output hole of the fan to the
hole in the wall using a flexible pipe.
Note:
Flexible pipe is not supplied.
9. The output air will be blown through the holes
in front panel of the unit in the re-circulation
mode.
10. Mount the fat (or carbon) filter.
11. Plug the supply cable into the wall outlet.
SUPPORTED ACCESSORIES
Metal filter 1 pc
Ord. No. 61990102
Price: See price list
Carbon filter 1 pc
Ord. No. 61990103
Price: See price list
SERVICE
Bulb replacement
Before replacement, let the bulb cool down. There is a risk of burning.
For the replacement proceed as follows:
• Pull the power cord out of the mains outlet or switch off the circuit breaker of the unit’s mains outlet.
• Remove the covering glass and replace the bulb with a new one of the same type (maximum 40 W)!
• Remount the covering glass.
Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an expert
service centre.
