![Concept2 LO 7010 Скачать руководство пользователя страница 25](http://html1.mh-extra.com/html/concept2/lo-7010/lo-7010_manual_2650417025.webp)
24
UK
LO 7010
Juicing
1. Put the fruit or vegetable to the filling feeder.
2. Set the switch to position "1" or "2" by pressing the button and push slightly the
ramming cap. When motor starts, add more fruit and vegetables.
3. The quantity of pressed juice depends on sort of fruit or vegetables. If you process
small fruit the juice quantity will be smaller due to high content of pectin (pectin is a
natural gel maker). The special presses are more suitable for these little fruits.
4. Before further use make sure that the motor
runs
slightly.
!
Never use fingers for ramming the fruit or vegetables to the filling feeder. Use only
the ramming cap.
!
Make sure that filter is clean.
Instruction for Juice Preparation
!
Buy only the freshest fruit and vegetable.
!
The fruit and vegetable contain valuable vitamins and minerals, which are
depreciated by contact with oxygen and light. Drink juice immediately after pressing.
!
If necessary to store juice for some hours place it in fridge in crockery or glassware.
You can improve its preservation ability by adding of lemon juice.
!
You can use the flesh for preparation of other meals (jams, stewed fruits etc.)
!
If the fruit is too watery (melons, etc.), then put it slowly in so that to obtain the
maximum quantity of juice.
!
When juicing too mellow fruit it can happen that the content of juice will be
relatively
small. In this case it is necessary to process the fruit very slowly enabling the juice to
flow out easily and prevent its clogging.
!
It is obvious that no clear juice is pressed when processing apples and banana.
!
To reach the maximum juicer efficiency it is recommended to clean the filter after
each half of kilogram of processed fruit. Disconnect the consumers from
mains
.
Wait, until the filter fully stops and take off the cover. Press the buttons for consumer
dismantling, take off the filter and remove the fruit flesh. At the same time clean the
flesh sticking to cover.
Cleaning and Maintenance
!
Disconnect the consumer from socket before any cleaning!
!
Immerse never the main body to water. Clean it by cloth.
!
All other parts can be washed under running water. The running water is more
efficient for cleaning.
!
The cutting/squeezing teeth are sharp ones. Handle them with care. Rinse them,
dry, and reassemble for storage.
!
If you process fruit or vegetables with high content of pigment, then the moles can
occur on plastic parts. Use vegetable oil for cleaning.