GENERAL INFORMATION
UNPACKING
This package contains:
• CID200 Caller ID Speakerphone
• Owner’s Manual
• One (1) Fully Modular Coil cord
• One (1) Quick Installation Guide
• One (1) Important Notice
• One (1) Safety Instructions for Batteries
• Two (2) Additional Memory Index Labels
• Warranty Card (Part of the Owner’s Manual)
If anything is missing or damaged, contact the place of purchase.
Keep the packaging to transport telephone.
For your reference, keep a record of the date purchased.
Please save the sales receipt for the warranty reference.
Date of Purchase ___________________________
INSTALLATION INSTRUCTIONS
Follow these precautions:
a. Never install telephone wiring during a lightning storm.
b. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
c. Never touch uninsulated telephone wires or terminals unless
the incoming telephone line has been disconnected at the
network interface.
d. Use caution when installing or modifying telephone lines.
TO INSTALL BATTERIES
Batteries are required for the Caller ID functions and Telephone
operations of the unit.
1. Remove the screw and open the battery door by pulling back
the latch.
CONGRATULATIONS!
You have purchased a CID200, 10-Memory Caller ID Telephone
manufactured to the highest standards of Conairphone
TM
. Before
installing and operating, be sure to read this manual.
LOCATION OF CONTROLS
4
5
21
22
20
18
15
13
12
11
10
17
14
16
19
9
8
1
2
3
4
5
6
7
1. Hook Switch
2. Receiver
3. Call Back Button
4. Pause Button
5. Receiver Volume Control
6. Priority Button
7. Transmitter
8. Memory Button
9. Store Button
10. LCD Display
11. New Call LED
12. Erase Button
13. Ringer Hi/Lo/Off Switch
14. Review / Button
15. Tone/Pulse Switch
16. Contrast Button
17. Volume Control
18. Keypad
19. Redial Button
20. Flash Button
21. Speakerphone LED
22. Speaker Button
2. Insert four (4) AA alkaline batteries (not included).
3. Snap the battery door back into place and replace the screw.
USING THE PHONE ON A DESK
1. Connect the coiled cord to the jacks in the handset and the
left side of the base.
2. Follow the “Setting up your CID200” instructions to set up
your telephone.
3. After the Caller ID setup has been completed, connect the
telephone line cord into the wall outlet.
HANGING THE PHONE ON THE WALL
The CID200 can be mounted on a standard wall phone plate
or two screws, installed 3
1
/
4
" vertically apart in the wall. Leave
3
/
16
" of each screw exposed for mounting the unit.
1. • On a wall phone plate
Coil the telephone line cord inside the wall mount pedestal
and slip the end of the cord through the rectangular
opening.
• On a Wall
Align the telephone line cord with the right slot on the top
and bottom of the wall mount pedestal.
2. To attach the wall mount pedestal, insert the tabs into the
slots in the base, making sure the telephone cords in the top
and bottom slots.
3. Attach the assembly to wall by inserting the two studs of the
wall plate (or the two screws) into the slots on the back of the
wall mount pedestal. Pull down gently for a snug fit.
4. Plug the coil cord into the handset and base jacks.
5. Follow the “Setting up your CID200” instructions to set up
your telephone.
6. After the Caller ID setup has been completed, connect the
telephone line cord into the wall outlet.
6