CONGRATULATIONS!
You have purchased a CID100, 10-Memory Caller ID Telephone
manufactured to the highest standards of Conairphone
TM
. Before
installing and operating, be sure to read this manual.
GENERAL INFORMATION
UNPACKING
This package contains:
• CID100 Telephone with Caller ID
• Owner’s Manual
• One (1) Fully Modular Coil Cord
• One (1) Fully Modular Telephone Line Cord (Long Straight
Cord)
• One (1) Fully Modular Telephone Line Cord (Short Straight
Cord)
• One (1) Quick Installation Guide
• One (1) Important Notice
• One (1) Safety Instructions for Batteries
• One (1) Additional Memory Index Label
• Warranty Card (Part of the Owner’s Manual)
If anything is missing or damaged, contact the place of purchase.
Keep the packaging to transport telephone.
For your reference, keep a record of the date purchased.
Please save the sales receipt for the warranty reference.
Date of Purchase ___________________________
INSTALLATION INSTRUCTIONS
Follow these precautions:
a. Never install telephone wiring during a lightning storm.
b. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
c. Never touch uninsulated telephone wires or terminals unless
the incoming telephone line has been disconnected at the
network interface.
d. Use caution when installing or modifying telephone lines.
TO INSTALL BATTERIES
Batteries are required for the Caller ID functions and Telephone
operations of the unit.
1. Open the battery door by pulling back the latch.
2. Insert four (4) AAA alkaline batteries (not included).
3. Snap the battery door back into place.
SETTING UP YOUR CID100
DO NOT CONNECT the line cord to the wall outlet until the
Caller ID setup has been completed.
The LCD shows ‘ENTER LANGUAGE’
followed by a choice of 3 languages
(English, Spanish, French). If your
display does not appear this way, press and hold both [ ] and
[ ] for 4 seconds.
The LCD then shows ‘ENG ESP FRA’.
NOTE:
The ‘ENG’ is BLINKING. Press
[ ] or [ ] to select ‘ENG’, ‘ESP’, or ‘FRA’.
Press [ERASE] to confirm.
If ENG is selected, the LCD shows ‘LCD
CONTRAST’.
Press [ ] or [ ] to adjust five levels (from
1 to 5, default is 3) contrast of LCD.
Press [ERASE] to confirm.
If contrast is set, the LCD shows
‘ENTER AREA CODE’. The first digit
‘–’ of the area code will blink.
Press [ ] or [ ] to enter the area code. Press [ERASE] to confirm
and go to next entry.
Repeat above steps until 3-digit area code is set.
LOCATION OF CONTROLS
4
5
6
1. Ringer Hi/Lo/Off Switch
2. Receiver
3. Receiver Volume Control
4. Hook Switch
5. Keypad
6. Tone/Pulse Switch
7. Redial Button
8. Store Button
9. Transmitter
10. Mem Button
11. New Call LED
12. LCD Display
13. Review / Button
14. Battery Compartment
15. Erase Button
16. Call Back Button
13
12
11
14
10
2
3
5
6
7
8
9
4
15
16
1
