Comtrol RocketPort INFINITY, Руководство пользователя

Страница: 8 / 36

8 - Card and Interface Installation RocketPort INFINITY User Guide : 2000465 Rev. G
Card and Interface Installation
Attaching a Quad/Octacable Interface Cable
Use this procedure to complete the quadcable or octacable installation.
1. Make sure that the host system is powered off before connecting the cable.
2. Attach the 68-pin end of the quadcable or octacable to the card.
Make sure that the
connectors are properly
aligned and forcefully push
the connector of the Quad/
Octacable with a rocking
motion into the card
connector. Make sure that
the connector is seated
tightly before tightening the
retaining screws on the
connector.
3. Tighten the retaining screws.
4. Power on the host system.
5. Click Cancel if a Found New Hardware message appears on a Windows
operating system.
Execute the device driver assembly to start the driver installation.
For other operating system device drivers, see Locating the Latest Drivers and
Documentation on Page 5.
6. After installing the driver, you should verify that the ports are functioning
properly and then connect your serial devices.
You can use the Troubleshooting section on Page 25 for port testing
procedures.
Refer to Connecting Serial Devices on Page 11 for information about
connecting serial devices.
Octacable
Quadcable
DB9
DB25
Caution