Installing the DeviceMaster 500 and the SICK LMS Scanner (Windows):
2000472 Rev. C
11
Software Installation
12. Connect the power cord of the scanner to a power source. When the scanner
displays a green light, you should see a message on the WCom2 window.
13. Use the
Port/Send ASCII / HEX String
menu to send the appropriate hex
commands using LMS scanner manual to perform these steps:
a.
Send a request to the scanner to start measuring.
b.
Send a request to the scanner to stop measuring.
c.
Send a request to the scanner to set the baud rate to 500K.
d.
After you get the
confirmation, change the
COM port setting in
WCOM2 to 500K by using
the
Settings/Port Settings
menu.
e.
make sure that the
scanner is working at
500K.
Note:
You can use this step for
any baud rate.
