Page 3
Pairing the Powerline Adapters
5.
Press the
Security
Button
on the PG-9182PT until you see the
Security LED
start blinking
GREEN
. Then you have up to 2 minutes to press the
Security
Button
on the PG-9182PoE
(hold the button until you see the
Security LED
start blinking
GREEN
). The
Security LED
and the
Connection LED
should be solid
GREEN
on both Adapters when they are
successfully paired. This could take up to 2 minutes.
Note: If you are adding to an existing G.hn Powerline network, then press the
Security Button
on
the adapter connected to your Network Device until you see the
Security LED
start blinking
GREEN
. Then press the
Security Button
on the Powerline Adapter you are adding until you see the
Security LED
start blinking
GREEN
.. The
Security LED
and the
Connection LED
will light up
GREEN
on all adapters within the G.hn Powerline network.
6.
Repeat Steps 3 to 5 to add additional Powerline Adapters. Please note that up to 16
devices can be connected within a Powerline G.hn network.
You Have Succesfully Set Up Your G.hn Powerline Network!
Troubleshooting
The following information should help you diagnose basic setup or installation problems.
Connection LED
is OFF:
The
Connection LED
shows that the Powerline Adapter is connected
to the G.hn Network. If the indicator is off, then plug both Powerline Adapters that you are
attempting to pair into power outlets that are located within the same room. The
Connection LED
should light up
GREEN
. If not, then press the
Reset Button
on each adapter for more than 10
seconds. Afterwards, you can plug the units back into their original location.
Security LED
is OFF:
If the
Security LED
is off, then it means the Powerline Adapter is not
securely paired. Press the
Security Button
on the Powerline Adapter for 3 seconds until you see the
E
F
D
