- 6 -
6. Install the Black Vinyl Cap on the top
element.
7. The two stainless steel V-Bolt Clamps are
used to secure the mounting plate to the
customer supplied mounting pipe described
earlier in this manual. When the antenna is
installed on the mounting pipe, tighten the V-
Bolts evenly so the length of the exposed
threads is approximately equal. Any V-Bolt
should be tightened evenly from side-to-side
with an equal amount of thread above each
nut.
8. Connect the center conductor of your coaxial
feedline to the studded band clamp. The shield
from your coaxial feedline must connect to
the base plate where you connect your radial
wires.
Frequency
MHz
Approximate Overall
Length
10.100
24 Feet 3/4 inches
10.125
24 Feet
10.150
23 Feet 11-1/4 inches
Figure 1
COMTEK 30 Meter
Vertical Antenna
Assembled Diagram
