Comtech EF Data XPA-200, Инструкция по установке и эксплуатации

Страница: 71 / 96

XPA200-7984-I-OPT1, X-Band SSPA Remote Control Remote Control
XPA200-7984-I-OPT1, Rev.2 5-19
XPA200-7984-I-OPT1 Remote Command Summary
Utility Commands Paragraph
Set Time <DEV/TIM_hh:mm:ss’cr’ 5.8.1.1
Set Date <DEV/DAT_mm/dd/yy’cr’ 5.8.1.2
Set Physical Address <DEV/SPA_xxx’cr’ 5.8.1.3
Set Baud Rate <DEV/SBR_xxxx’cr’ 5.8.1.4
Set Parity Rate <DEV/SPB_xxxx’cr’ 5.8.1.5
Set LCD Contrast <DEV/CON_xx’cr’ 5.8.1.6
Set LCD Brightness <DEV/LCD_xx’cr’ 5.8.1.7
Retrieve Equipment Type <DEV/RET_’cr’ 5.8.1.8
Set Application ID Message <DEV/AID_xxx...xxx’cr’ 5.8.1.9
Configuration Commands Paragraph
Set Amplifier ON/OFF <DEV/AMP_xxx’cr’ 5.8.2.1
Mute/Unmute <DEV/MUT_xxx’cr’ 5.8.2.2
Set Attenuation <DEV/ATT_xx.xx’cr’ 5.8.2.3
Select Auto Fault Recovery <DEV/AFR_xxx’cr’ 5.8.2.4
Status Commands Paragraph
Retrieve Configuration Status <DEV/RCS_’cr’ 5.8.3.1
Retrieve Maintenance <DEV/RMS_’cr’ 5.8.3.2
Retrieve FET Status <DEV/RFS_’cr’ 5.8.3.3
Retrieve Utility Status <DEV/RUS_’cr’ 5.8.3.4
Retrieve Alarm Status <DEV/RAS_’cr’ 5.8.3.5
Summary Alarm Status <DEV/SAS_’cr’ 5.8.3.6
Terminal Status Change <DEV/TSC_’cr’ 5.8.3.7
Packed Configuration Status <DEV/PACRCS_’cr’ 5.8.3.8
Packed Maintenance Status <DEV/PACRMS_’cr’ 5.8.3.9
Packed FET Status <DEV/PACRFS_’cr’ 5.8.3.10
Packed Utility Status <DEV/PACRUS_’cr’ 5.8.3.11
Packed Alarm Status <DEV/PACRAS_’cr’ 5.8.3.12
Stored Alarm Commands Paragraph
Retrieve Total Stored Alarms <DEV/TSA_’cr’ 5.8.4.1
Clear All Stored Alarms <DEV/CAA_YES’cr’ 5.8.4.2
List All Stored Alarms <DEV/LAA_’cr’ 5.8.4.3