Comtech EF Data Vipersat SLM-5650A, Инструкция по установке и эксплуатации

Страница: 218 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–24 MN-SLM-5650A
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Rx Buffer Size RBS= RBS? 8 bytes Command or Query.
Sets or return the Rx Buffer Size in the form xxxxxxxx, where:
xxxxxxxx=Rx Buffer Size (in either bits or milliseconds – see RBM
command)
Note: This command or query are not allowed when either the GBEI
or NP Module is selected as the current interface type.
Example:: <0001/RBS=00000512{CR}
RBS=
RBS?
RBS*
RBS#
RBS=xxxxxxxx
ReCenter Buffer RCB= N/A None Command only.
Forces the firmware to recenter the receive Plesiochronous / Doppler
buffer.
Notes:
1) This command takes no arguments.
2) This command is not allowed when either the GBEI or NP
Module is selected as the current interface type.
RCB=
RCB?
RCB*
RCB#
N/A
Rx Clock Invert RCI= RCI? 1 byte Command or Query.
Sets or returns the Invert Receive Clock in the form x, where:
0 = Normal
1 = Inverted
Example: <0001/RCI=1{CR} (selects Inverted RX Clock)
RCI =
RCI?
RCI*
RCI#
RCI=x
Rx Clock
Source
RCK= RCK? 1 byte Command or Query.
Sets or returns the Rx Clock Source in the form x, where:
0 = Rx Satellite
1 = Internal
2 = Tx-Terrestrial
3 = External Clock (only valid with the G.703 Option Card)
Note: This command or query are not allowed when either the GBEI
or NP Module is selected as the current interface type.
Example: <0001/RCK=2{CR} (selects Tx-Terrestrial)
RCK=
RCK?
RCK*
RCK#
RCK=x