Comtech EF Data SDM-300A, Инструкция по установке и эксплуатации

Страница: 277 / 398

Remote Control Operation SDM-300A Satellite Modem
B–2 Rev. 4
B.2 Message Structure
The ASCII character format used requires 11 bits/character:
•
1 start bit
•
Information and Parity bits (select one)
!
7 information bits and 1 parity bit (Odd/Even)
!
8 information bits (None)
•
2 stop bits
Messages on the remote link fall into the categories of commands and responses.
Commands are messages which are transmitted to a satellite modem, while responses are
messages returned by a satellite modem in response to a command.
The general message structure is as follows:
•
Start Character
•
Device Address
•
Command/Response
•
End of Message Character
B.2.1 Start Character
A single character precedes all messages transmitted on the remote link. This character
flags the start of a message. This character is:
•
“<”
for commands
•
“>”
for responses
B.2.2 Device Address
The device address is the address of the one satellite modem which is designated to receive
a transmitted command, or which is responding to a command.
Valid device addresses are 1 to 3 characters long, and in the range of 1 to 255.
Note: Address 0 is reserved as a global address which simultaneously addresses all devices
on a given communications link. Devices do not acknowledge global commands.
Each satellite modem which is connected to a common remote communications link must
be assigned its own unique address. Addresses are software selectable at the modem, and
must be in the range of 1 to 255.