Comtech EF Data DT-4500 Series, Инструкция по установке и эксплуатации

Страница: 74 / 206

DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM
Front and Rear Panel Connectors Revision 2
4–18
The ‘J3 | HSB’ connector does not employ a “straight-through” cable
assembly. Contact Comtech EF Data Product Support for detailed
cabling instructions when cabling between converters in redundant
applications.
4.2.4.2 Removable Module Operation in Non-Redundant
(Standalone) Applications
A converter may use a Transmit Switch Module (TSM) or a Receive Switch
Module (RSM) in standalone configurations if an IOM ( Figure 4-17 ) is
unavailable.
Note that the High Speed Bus ‘J3 | HSB’ connector is not used in standalone
configurations. If a module other than an IOM is used, only the ‘J4 | IF’ and ‘J5 |
RF' connectors are used to connect directly to the user input/output signal
sources ( Figure 4-18 ).
Figure 4-17. DT-4500 Standalone Cabling Example to IOM
Figure 4-18. DT-4500 Standalone Cabling Example to RSM