Comtech EF Data DMD1050TS, Инструкция по установке и эксплуатации

Страница: 275 / 316

DMD1050TS Satellite Modem Board
Revision 1
Appendix H H–3 MN-DMD1050TS
H.5 Demonstration Procedure
The procedure for enabling a 30-day demonstration of the options is similar to the procedure
used for permanently upgrading the features. However, at the end of 30 days, the demonstration
features are disabled automatically.
At the end of the demonstration period, the modem reverts to its permanent configuration
automatically. Traffic interruption can occur, even if demonstration features were active. Operator
intervention is necessary to restore the data paths.
To avoid this interruption in service, cancel the demonstration before the end of the period. See
Section H.6 for instructions.
H.5.1 Find the Available Features
1. Use the GUI interface
2. Go to System > Features
3. Click Features
The screen shows all available features. Checked features are those already purchased and
installed.
H.5.2 Find the Unit ID
1. Use the Terminal interface
2. Go to Main > Features
3. Find Feature Id
The Feature Id value on the top line is the 12-digit Unit ID. Example: 1 2 3 4 . 1 2 3 4 . 1 2 3 4
The Customer Service representative will ask you for the Unit ID and the desired feature set
when taking your request for a demonstration.
H.5.3 Request a Demonstration
Contact Customer Service and request a demonstration. Once the request is processed, you will
receive a 12-digit demonstration code. This code works once only, on the modem for which it was
ordered.
H.5.4 Enter the Demonstration Code
CAUTION
Make sure to enter the code correctly. After three unsuccessful attempts to enter
a code, the modem locks out the upgrade and demonstration capability. To
continue, you must cycle power on the modem.
1. Enter the demonstration code from the terminal port:
a. On the Enter Selection Number line, type 45
b. Press Enter
c. Enter the new code
d. Press Enter
If the code is entered correctly, the CODE ACCEPTED message shows.
Otherwise, the INVALID CODE message shows. Repeat all of Step 1, and make sure the code
entered is correct.