BEFORE LOOKING FOR HELP
Q4M/Q8M
8
YOUR TROUBLE
THE CAUSE AND ITS SOLUTION
After connecting the sup-
ply voltage device does
not work.
The power supply is not connected.
Check the supply connector and the polarity of power supply,
switch on the power breaker.
The supply adapter is not dimensioned sufficiently.
Check if the adapter power output and voltage agree with the quad
requirements.
After connecting the sup-
ply voltage the LEDs are
on, but the device does
not work.
The supply adapter is not dimensioned sufficiently.
Check if the adapter power output and voltage agree with the quad
requirements.
Horizontal stripes go over
the quad screen.
The supply adapter is not dimensioned sufficiently.
Check if the adapter power output and voltage agree with the quad
requirements.
Horizontal stripes appear
over the individual screen
quadrants.
Strong interference from power distribution has debased the cam-
era signal
.
Check the camera connection.
Check the camera and monitor ground conductor.
Automatic switching se-
quence
can
not
be
switched on.
Cameras listed in the switching sequence are off from the switch-
ing.
Correct the sequence and check the sequence period (page 6).
The picture in the quad
screen has stopped.
The picture has been stopped from the keyboard.
Check the LEDs on the display (page 5). Press and keep the but-
tons of the shining LEDs 1
– 8.
Camera was disconnected or switched off.
Check the camera power supply and connection.
Device does not react to
alarm inputs.
The alarm processing is switched off in the main menu.
Set up the alarm with the function of ALARM (page 6).
The connection of the alarm signals is disconnected.
Check the connection of the alarm connector.
There is no picture on the
monitor.
The quad and monitor patchcord is defective.
Check the patchcord carefully.
