Target interface
(H8S/2367F, H8S/2368F)
Mar. 03, 2008 (Second Edition)
■
H8S/2367F, H8S/2368F
Applicable products
PALMiCE2-H8S
Applicable connectors
(Connectors for debugger)
MIL connector (14-pin design)
MIL connector
Signals
CPU Pin No.
CPU Pin No.
2367F, 2368F
2367F
2367F, 2368F
2367F
Pin
No.
Signal
Input/
Output
*1
TFP-120/120V FP-128/128BV
Pin
No.
Signal
Input/
Output
*1
TFP-120/120V FP-128/128BV
1 PG4
*4
Input 106
116 2 GND
3 P53
*4
Input 112
122 4 GND
5
WDTOVF
*4
Output
31 37
6
GND
7
RESIN
*2
Input
8 VCC
*3
Output
9 PG5
*4
Input 107
117 10 GND
11 PG6
*4
Input 108
118 12 GND
13
RES Output
77 85
14
GND
*1: Input/output is based on the target system.
*2: RESIN is not a name of CPU pin. RESIN signal cannot be directly connected to CPU pin. For connection, consult the target connection
reference diagram.
*3: For VCC, connect I/O power of CPU. Debugging can be performed even if the signal is N.C., however, if you connect I/O power, it will allow
prevention of leak during the target system power OFF and adaptation to power 1.8V-3.6V range.
Note, for input, it is 5V-tolerant. If optional conversion adapter (ADP-HUDI-5V) is used, 5V is supported for output.
*4: PG4, PG5, PG6, P53 port functionality, other functionalities multiplexed in those pins, and functionalities of WDTOVF pin will not be
available since those pins are occupied by the debugger.
Target connection reference diagram
MIL connector specifications
Recommended connector
Manufacturer Omron
Corporation
Model XG4C-1431
(Top view on the target board)
(For detailed dimensions of the connector,
refer to the documentation by manufacturer.)
*1: When debugging, bring EMLE pin to High state.
Shown in the target connection reference diagram is the circuit that brings EMLE pin to High state when you turn OFF the switch.
*2: RESIN, which is connected to Pin No.7 of the connector for debugger, is the signal that the debugger outputs to CPU. Connect the signal to
CPU by using user logic reset circuit with reference to the logic shown in the target connection reference diagram.
*3: RES, which is connected to Pin No. 13 of the connector for debugger, is the signal that debugger uses for monitoring the state of RES pin of
CPU.
