Compu-Video Systems CVDA-2, Инструкция по эксплуатации

Страница: 4 / 12

P.O. Box 749 Peekskill, NY 10566 Tel: (845) 737-7009 Fax: (845) 737-0426 Web: www.compuvideosystems.com
SIGNAL ADJUSTMENTS
On the CVDA-2 there are openings on the side of the unit for the gain and high frequency
controls. Insert a small straight edge screwdriver to adjust. Connect a signal to the video
“in” of the unit. With an oscilloscope connected to the output and the output cable
terminated in 75 ohms, adjust the gain control so that the sync signal is 280mv or if a 1VPP
test signal is available, adjust the gain control for an overall level of 1VPP at the end of the
cable.
On the CVDA-2, the High Frequency control is adjusted for the sharpest picture desired.
Fig. 1
Control Locations
PLACEMENT IN SYSTEM
The CVDA-2 should be placed as near the end of a system as possible for ground loop
protection.
1) Disconnect the feed from the camera at the end by the monitor, switcher or VCR.
Connect the camera feed to CVDA-2 input. Connect one output to your monitor,
switcher or VCR. and verify that the hum is reduced or eliminated.
2) Adjust the video gain for the desired level
3) Adjust the High Frequency control for the sharpest possible picture.
GAIN High Frequency