Comprag D7510, Руководство пользователя

Страница: 26 / 92

+7 (800) 777-83-75(звонок бесплатный)
www.v-p-k.ru D7510
5.2 Checking oil level
Check oil level on a daily basis. In order to
access the oil level, stop the compressor
and remove the front side panel. The oil
level in the compressor should be checked
visually with the oil level glass (1) when the
compressor has stopped. The surface of the
oil must always be visible in the sight glass
If no oil is visible in the sight glass, the oil
level is low and needs to be topped up.
Using belt tension gauge, check the tensile
force of the compressor belts.
Fig. 5.2 Checking oil level
5.3 Replacing oil and oil filter
2
1
Fig. 5.3.1 Oil replacing
Open the left panel and turn the fill plug (2)
one revolution in order vent system pres-
sure. Remove the fill plug. Remove plug
from the drain valve (1) at the bottom of
the Air-Oil separation tank. Drain the oil
into a dedicated vessel from the
separator tank after opening the drain
valve.
Fill the Air-Oil separation tank with oil until
it is level with the middle of the sight glass.
Refit and tighten the drain valve plug and
the fill plug.