8. Using 18 AWG, 600V, 105° TYPE AWM1 or CSA-TEWN solid conductor wire, re-wire lamp holders as shown in the wiring
diagram, including power supply leads from Step 5. Verify all leads are retained in lamp holder ports with a gentle pull.
9. Install re-wired lamp holder set on the same side. Insert from underside of retaining plate. Push to lock retaining tabs.
This is now the line side of the luminaire.
10. Reconnect disconnect, separated in Step 5.
11. IMPORTANT: Apply supplied self-adhesive label “POWER TO THIS END ONLY” above re-wired lamp holders.
Label must be visible for lamp installation.
12. Replace wiring compartment and/or reflector removed in Step 4.
13. IMPORTANT: Apply supplied self-adhesive label “NOTICE NOT FOR USE WITH FLUORESCENT LAMPS.
Order replacement LED-T8 lamps – 800.526.3694”.
14. Install LED lamps with power input as marked on lamp, matched to labeled lamp holders.
15. Reinstall lens cover.
16. Restore power to fixture.
Note: Original ballast circuit will be disabled in Step 5. Lamp holders originally wired to ballast will also be electrically disabled,
used only to support lamps when installed. Ballast with related wiring may remain in place, electrically disabled.
POWER SUPPLY DISCONNECT
PULL APART TO SEPARATE
POWER SUPPLY DISCONNECT
STEP 5
CUT WIRES NEAR TO BALLAST
AND NEAR TO LAMP HOLDERS
STEP 6
REMOVE LAMP HOLDERS
WIRING DIAGRAM
FROM STEP 5
BLACK
WHITE
BLACK
WHITE
RETAINING TAB
COPPER STRIP
STEP 8
REWIRE LAMP HOLDERS
STEP 9
INSTALL RE-WIRED
LAMP HOLDERS
FIXTURE ENCLOSURE
BALLAST-WIRING
FIXTURE ENCLOSURE
LED LAMP-WIRING
3 INCH
POWER SUPPLY DISCONNECT
PULL APART TO SEPARATE
POWER SUPPLY DISCONNECT
STEP 5
CUT WIRES NEAR TO BALLAST
AND NEAR TO LAMP HOLDERS
STEP 6
REMOVE LAMP HOLDERS
WIRING DIAGRAM
FROM STEP 5
BLACK
WHITE
BLACK
WHITE
RETAINING TAB
COPPER STRIP
STEP 8
REWIRE LAMP HOLDERS
STEP 9
INSTALL RE-WIRED
LAMP HOLDERS
FIXTURE ENCLOSURE
BALLAST-WIRING
FIXTURE ENCLOSURE
LED LAMP-WIRING
3 INCH
