Component Engineering STRD-30C, Руководство пользователя

Страница: 5 / 12

4
Analog pre-amp
Wiring
Connect both of the LEDs to the outputs of the LS-30 power
supply chassis. The small terminal strips at the
rear of the LED
assembly can be unplugged by pushing away from you. Note that
no polarity is indicated. This is because the LEDs may come with
either polarity and you will have to determine the correct
connection by trial and error. It is safe to do this because the
output of the LS-30 power supplies is clamped at a voltage too low
to damage the LEDs. The recommended wire size is #18 AWG.
The
analog pre-amp is powered by the 12 Volt bipolar supply in
the LS-30 and three conductor 22 Gauge wire is perfectly adequate
for this purpose.
The analog audio output from the pre-amp should be two shielded
pairs, one for each channel. They can be individual cables, or two
pairs in one jacket. Normal audio wire such as you would use for
any other purpose is ideal.
All of the terminal strips on the analog pre-amp can be unplugged
at the pre-amp.