Compliance West GFM-40ac, Инструкция по эксплуатации

Страница: 11 / 19

7
USA
CONDUCTIVE JEWELRY AND WATCHES BEFORE USE.
SEE OWNERS MANUAL FOR CALIBRATION INSTRUCTIONS.
REMOVE
CAUTION:
HIGH CURRENT GROUND CONTINUITY TESTER
MODEL NO.
SERIAL NO.
CAUTION:
HIGH CURRENT - BURN HAZARD!
RISK OF ELECTRIC SHOCK
DO NOT OPEN.
FOR CONTINUED PROTECTION AGAINST RISK OF
FIRE, REPLACE ONLY WITH 3A 250 V TYPE T FUSE
120V 60HZ 1.5A
SAN DIEGO, CA 1-800-748-6224
DURATION
VOLTAGE ZERO
1
0
CALIBRATION RESISTOR
3
1
2
Figure 2-2. Controls, Indicators, Connectors - Model GFM-40ac Rear Panel
ITEM NO. NAME FUNCTION
1 Voltage Zero Used to adjust meter. See "Calibrating the GFM-40ac
Tester" section of this manual for procedure.
2
Test Duration Setting
Used to set test duration. Set to test durations between 1
and 120 seconds.
3 Appliance Inlet / Fuseholder /
Power Switch Uses 18 AWG cordset to connect tester to appropriate
source of supply. Replace line fuse. Turn tester
ON/OFF.
Table 2-2. Controls, Indicators, Connectors - Model GFM-40ac Rear Panel