Compex WPJ558 HW, Руководство пользователя

Страница: 9 / 13

WPJ558 Hardware Manual
7
Ethernet Connectors
The board contains 2 X 10/100/1000 Base-T Ethernet Channels. The Ethernet Channels are available
through standard 8-pin RJ45 connectors.
Ethernet Connectors(P1/P2) signals is shown below.
PIN SIGNAL PIN SIGNAL
1 TX+/POE+ 5 TX-/POE+
2 TX-/POE+ 6 RX-/POE-
3 RX+/POE- 7 RX+/POE-
4 TX+/POE+ 8 RX-/POE-
JTAG PROCESS
Minimum Requirement
1. OCD Commander ver2.5.4
2. upbios.tst file (same for all Compex device)
3. uboot.bin file
4. JTAG cable
Steps
1. Install the OCD Commander to your PC
2. Plug the JTAG cable to the JTAG port of the device
3. Run OCD Commander Program, Set "Target Processor" for the particular device, Click "OK"
4. If there is this error message “Error Response from INITIALIZE....”, please check the JTAG cable
connection. Close the OCD Commander Program and go back to Step 3.
5. Click on the “Macro” and choose a specific .mac file.