10
Compex 16-Port All 10/100 Switch
DS2216
English
2b.
Now press the Set button once and it will cycle to the next port. Port #1
LED lights up first. Press the Set button again to jump to next port #2.
Continue to press several times until the desired port LED lights up.
To set this port, press the Set button and hold it down for about 3
seconds until all ports LEDs flash once. When successful this port LED
will remain lighted up for Half-Duplex mode and if Full Duplex mode
setup the LED will turn OFF.
•
How to force a certain port to 10Mbps speed and Half-duplex
mode
Note
10Mbps and Full-Duplex combination is not supported.
1a.
Press the Mode button several times until the Half LED lights up.
Check the LED for that port number you want to set.
If the port LED lights up it is already forced to Half-Duplex mode.
Skip and go to step (2a). Otherwise, proceed to (1b).
1b.
Now press the Set button once, it will cycle to the next port. Port #1
LED lights up first. Press the Set button again to jump to the next port.
Continue to press several times until the desired port LED lights up.
To set this port, press the Set button and hold it down for about 3
seconds until all ports LEDs flash once. When successful, this port
LED will remain lighted up.
2a.
Next press the Mode button until the 100M LEDs lights up. Check the
LED for that port number you want to set.
If it is not lighted up it is already in 10Mbps mode. Do nothing.
Setup is completed.
If it lights up, go to (2b) to toggle to 10Mbps mode.
