G. Operation of the Scale (weighing powder):
1. Turn the scale on by pressing the "ON" key and wait until the display reads "0.00"
grams. If the scale is not in the mode desired, then press the MODE key to change the
weight unit accordingly. The selected weight capacity (grams or grains for example)
will remain even when the scale is turned off and then on again. Once the proper weight
capacity is selected, the scale is ready to weigh powder.
2 Place an empty powder pan on the scale.
FIG 12
3. If there are environmental variables affecting the scale's performance, then lower the
Draft Shield to stabilize the readings.
4. Press the ZERO key to
"zero out" the scale. This
will remove the powder
pan weight allowing only
the powder itself to be
weighed. This function is
called "TARE Function"
FIG 11
5. Wait till the scale reads
"0.00". At this point the
scale can be used to weigh
any object that will fit on
the platform (within the
weight range of the scale).
6. Pour powder into the
powder pan. Allow 3-4
seconds for the display
to settle (because of the
scale's extreme sensitivity,
the display may fluctuate
slightly, if so, check for
vibration or air move-
ment). Read the weight of
the scale.
7. Turn the scale off when
you are finished.
FIG 12
F. Re- Zero Function:
Press the "ZERO" key at any time to
re-zero the scale. This is a good idea if it
is moved during a weighing process.
FIG 11
FIG 11
CED Professional Digital Scale manual.indd 5
14/10/2016 16:40
