Appendix D - When the “Over Temp” Light Comes On
35
Replacing or Cleaning the Intraport Enterprise-2 Air Filter
Under normal operation, the air filter does not require periodic maintenance. The filter should
be replaced only when an excessive amount of dirt and dust has collected over an extended
period of time. A replacement filter is supplied with the unit to minimize the unit’s down time
when the filter is replaced.
Before attempting to change or clean the filter, the unit must be removed from its mounting in
an equipment rack or on a wall. Changing or cleaning the filter is a simple process.
Figure 10. Removing the Chassis Cover and Filter
1.
Remove the front three vertically aligned screws and the middle three horizontally
aligned screws from each side of the chassis, as illustrated in Figure 10.
2.
Remove the top panel from the chassis.
3.
Remove the filter from its slot.
4.
Put the supplied replacement filter in the slot. The used filter may be washed in
warm, soapy water and used again once it is completely dry.
5.
Replace the top panel.
6.
Fasten the top to the chassis with the screws you removed in Step 1.
7.
If the chassis was removed from an equipment rack, return it to its mounting, follow-
ing the instructions as outlined in Chapter 2 - Mounting Instructions.
v
Note:
If either of the supplied filters is worn out or cannot be thoroughly cleaned, you may
order a replacement filter from Compatible Systems Corporation at the number in the front of
this manual.
