Compatible Brands CB24WINEDUAL, Руководство пользователя

Страница: 8 / 16

7
NOTE: All parts removed must be saved to allow the door swing to be reversed
1. Carefully use a sharp tool to pry up the decorative cap on the top of the cabinet
and the cap of the door spindle. (Fig 1)
2. Open the door about 90°, unscrew the screw of the upper door hinge cover and
remove the cover, then unscrew all the screws on the upper door hinge. Be sure
to hold the door firmly after removing the screws, and take off the door. (Fig 2)
3.
Remove the screw of the lower door hinge, door support and the left side screw
of the front vent (Fig 3), then install the lower door hinge and lower door support
at the designated position on the opposite side.
(Fig 4)
4. Remove the screw of the door handle, then remove the bottom screw on the left
side of the door and remove the lower support of the door (Fig 5). Install the
lower support of the door on the opposite side. (Fig 6).
5. Gently pull open the middle section of the door gasket; you will see the handle
screw hole (Fig 7). Remove the handle and install it on the opposite side.(Fig 8)
6. Loosely install the upper door hinge on the opposite side. (Fig 9)
7. Set the door onto the shaft of the lower door hinge (Fig 10), then fit the shaft of
the upper door hinge into the top of the door (Fig 11) and tighten the screws.
Adjust the door so it is aligned with the cabinet. Level the cabinet and tighten all
the lock screws.
You also can call customer service for door reversal instructions if necessary
.