26
E
item 07 272
!
Use and store the product away from flammable and volatile substances.
!
Do not expose the product to extreme temperatures, direct sunlight, neither place it in an excessively dusty
environment.
!
Do not place the product near heaters, open fires and other appliances or heat sources. Never leave the pro-
duct unattended.
!
Let the engine cool down, before placing in a closed room.
!
Do not repair the product yourself, neither make any adjustments! Have all repairs and adjustments of this
product carried out by an authorized workshop or retailer. By breaking down the product during the warran-
ty period, you expose yourself to the risk of warranty loss.
!
The manufacturer is not responsible for damages caused by improper use of the product and its accesso-
ries (injuries, burns, scalding, fire, degradation of food, etc.).
Electrical safety
!
The machine can be connected to any shock-absorbing plug installed according to the standards.
!
The machine may only be powered by 230 V ~ 50 Hz.
!
Disconnect the machine if you do not use it, or if you are replacing or servicing any parts.
!
Any worn or damaged parts must be replaced by qualified personnel.
!
If the power cord is damaged, it must be replaced by the manufacturer or his service representative or simi-
larly qualified person to avoid danger.
Maintenance and storage
!
Except for nozzle cleaning, this machine does not require any special maintenance. The same applies to
electrical parts.
!
Check the device for signs of wear and tear.
!
If damage (packaging, wires, construction) occurs, ensure that it is replaced immediately by a workshop or
dealer.
!
Regular machine care ensures not only long service life and performance.
!
Always inspect the machine visually before work, if it is worn or damaged.
!
Worn or damaged parts of the machine may only be replaced by an authorized repairer or by the dealer.
!
Always disconnect this product from the power source before cleaning.
!
Use a soft cloth moistened with lukewarm water to clean the plastic parts of the product. Do not use abrasi-
ve cleaners, thinners or solvents, otherwise the surface of the product may be damaged.
!
Do not immerse the machine in water.
Troubleshooting
Problem
Non-continuous waterflow
The engine isnt starting, stops suddenly
The engine is running, low water pressure
Possible solution
The nozzle is probably dirty, clean the nozzle
Check the socket and fuses. The thermal fuse inside the
machine could turn off the device. Allow the machine to
cool for about 5 minutes and try again.
The pump could draw air. Check the water inlet hose for
tightness.
There is little water or low pressure from the tap - check
that the tap is fully open.
