. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-3
Compaq Netelligent 1016 10Base-T Unmanaged Repeater User Guide
Writer:
Liz Fischer
Project:
Setting Up the Repeater
Comments:
268749-001
File Name:
749_3.doc
Last Saved On:
6/25/96 9:30 AM
3. To install the brackets in the repeater, insert the bracket clips into the
bracket slots on the bottom of the repeater. The brackets rest flat against
the bottom and the sides of the repeater, while the mounting holes that
secure the bracket to the rack face the front of the repeater. To flush-
mount the repeater, use Slots 1 and 3 (see Figure 3-1). To have the
repeater extend slightly out of the rack, use Slots 2 and 4.
4. Push the bracket back until you feel it snap over the plastic ridge inside
the mounting slot. Figure 3-1 shows the installation of the brackets in
the repeater.
Left Bracket
Right Bracket
Bracket Clips
Left
Bracket
Slots
1
2
3
4
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
16
Right
Bracket
Slots
4
3
2
1
Bottom of Repeater
Figure 3-1.
Installing the Mounting Brackets in the Repeaters
5. Turn the repeater face up.
6. Select the height at which you want to install it in the rack and align the
right and left mounting brackets with a matching hole pattern. Position
the brackets on the inside of the wall rack.
7. Fasten the mounting brackets to the wall rack using the four screws
provided.
To remove the repeater from the rack, follow these steps:
1. Leave the repeater on the mounting brackets and unscrew the mounting
brackets from the rack. Be sure to support the repeater during this
procedure so that it does not fall from the rack.
