Compaq D310v - Evo - 256 MB RAM, Быстрая настройка

Страница: 26 / 32

2–14 Quick Setup & Getting Started Guide
Getting Started
Diagnostic Keyboard LEDs, Front Panel LEDs and
Audible Codes
The following table describes the keyboard and front panel LED
codes as well as the audible codes that may occur during Power On
Self Test (POST) that do not necessarily have an error code or text
message associated with them.
✎
If your system is equipped with a Universal Serial Bus (USB)
keyboard, you may hear the beep sequences for some of the keyboard
light error codes, but you may not see the flashing keyboard lights.
Diagnostic Keyboard LEDS, Front Panel LEDs and Audible Codes
Activity Beeps Probable Cause Recommended Action
Audible 1L, 3S* System ROM is
corrupted; system is
running in Failsafe Boot
Block mode. Reflash the ROM using a
ROMPaq diskette.
Flashing
Caps Lock
LED on Keyboard.
1L, 2S* Graphics controller not
present or incorrectly
initialized. 1. Clear CMOS.
2. If graphics card has been
added, remove and
reseat.
Flashing
Num Lock
LED on keyboard
(on select models.)
1S, 2L* System memory not
present. 1. Check memory module
(see the relevant section of
the
Hardware Reference
Guide ).
2. Remove and reseat
memory module.
Ä
CAUTION:
Some models support ECC memory and non-ECC memory. Other models
support only non-ECC memory. For those systems that do support ECC memory,
Compaq does not support mixing ECC and non-ECC memory. In addition, the system
will not boot the operating system.
*L = Long, S = Short
293386-001.book Page 14 Friday, July 12, 2002 5:04 PM