Removal and Replacement Procedures
Compaq ProLiant BL20p Server Blade Maintenance and Service Guide
2-11
COMPAQ CONFIDENTIAL
Codename: AvalancheX Part Number: 316080-001 Last Saved On: 12/18/02 11:31 AM
Processor Assembly
To remove a processor assembly:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2. Remove the access panel. Refer to the “Access Panel” section in this chapter.
CAUTION:
Always disengage the heatsink clip
before
raising the processor ejector lever to
avoid damaging the pins.
3. Disengage the retaining clip (1). Be sure that the clip unfastens from both sides of the
processor socket.
4. Lift the ejecting lever (2).
5. Remove the processor assembly (3).
1
2
3
Figure 2-8: Removing a processor assembly
CAUTION:
Do not disassemble the processor assembly. Separating the parts damages
them.
IMPORTANT:
Align the pins with the socket before seating the processor assembly. The assembly is
keyed to fit only one way.
Reverse steps 1 through 5 to replace the processor assembly.
