Connecting the Actuator Cable to the Lock
Mechanism
The actuator cables are attached to the door lock control unit. Use the short
cable to connect to the front lock mechanism and the longer cable to
connect to the rear lock mechanism.
To connect to the front lock mechanism, feed the actuator cable
2
through
the gap between the rack rail and frame. Slide the lever
1
and place the
actuator cable
2
into the opening, making sure to secure the end of the
cable
3
over the slot.
Repeat procedure to connect to the rear lock mechanism.
CAUTION:
The actuator cable should be installed with a bend radius of at
least 100 mm to avoid kinking the cable. Do not bend or squeeze the
actuator cable.
Adjusting the Lock Mechanism
Turn the adjusting connector
1
until the edge of the latch
2
on the lock
mechanism moves above the edge of the opening. Secure with the locknut
3
.
Installing the Door Lock Control Unit
Position the control unit between a front and rear rail. Attach the brackets to
the door lock control unit, using the M3 screws
1
Attach the brackets to
the rails using self-tapping screws
2
. The control unit can face up or down
depending on specific installation requirements.
Continued on reverse
Installation Card For
Door Lock Kit
Read Instructions Completely Before
Beginning Installation Procedures
Printed on recycled paper
NOTICE
© 2001 Compaq Information Technologies Group, L.P.
Compaq and the Compaq logo are trademarks of Compaq Information Technologies
Group, L.P.
Compaq shall not be liable for technical or editorial errors or omissions contained herein.
The information in this document is provided as is without warranty of any kind and is
subject to change without notice. The warranties for Compaq products are set forth in the
express limited warranty statements accompanying such products. Nothing herein should
be construed as constituting an additional warranty.
Compaq Console Management Controller Door Lock Kit Installation Instructions
Second Edition (December 2001)
Part Number 240828-022
About This Device
This document provides instructions to assist qualified personnel
with the installation of the Compaq Console Management
Controller (CMC) Door Lock Kit.
This door lock kit includes the following features:
■
Installs in the 9000 and 10000 series of Compaq racks.
■
Mounts in a 0U configuration.
■
Provides front and rear door locking control for a single rack.
Regulatory Compliance Information
This CMC Door Lock Kit is listed and certified for use only with
the Compaq Console Management Controller Units. This device
is not intended for use with nor suitable for connection to facility
burglary protection, security, or surveillance systems.
Regulatory certification for this product was obtained under
agency series number EO3009L. The corresponding part number
is 203039-B23.
Read Before Installing Product
Read the
Important Safety Information
guide (included with this
kit) before installing this product.
WARNING
: There is a risk of personal injury from electrical shock and
hazardous energy levels. The installation of options and routine maintenance
and service of this product must be performed by individuals who are
knowledgeable about the procedures, precautions, and hazards associated
with AC power products.
Follow the instructions in this document during installation of the
door lock kit.
Kit Contents
■
Door lock control unit
- Mounting brackets (257661-001)
■
Country-specific power cord
■
Front rack door
- Lock assembly
- 91XX, 9842, and 106XX (257662-001)
- Latch assembly
- 91XX and 106XX (257662-002)
- 9842 (257662-003)
■
Rear rack door
- Lock assembly
- 91XX, 9842, and 106XX (257663-001)
- Latch assembly
- 91XX and 9842 (257663-002)
- 106XX (257663-003)
- Brackets
- Standard rack (257664-001)
- Standard rack with extension kit (257664-002)
■
Tie wraps
■
Cables
- Concealed Door Release cable assembly (257658-001)
- CMC lock command cable (231915-001)
- I
2
C communication cable (231526-002)
■
Software
- Compaq Intelligent Rack Manager Lite CD
- Power Products Documentation CD
■
Mounting hardware
- Screws
- Cage nuts
3
C
ONSOLE
M
ANAGEMENT
C
ONTROLLER
2
1
1
2
1
2
3
1
2
1
3
2
240828- 022
