COMPANION 315.101810, Руководство оператора

Страница: 8 / 18

8
3
Fig. 2
CHARGING
ASSEMBLY
BATTERY
PACK
CHARGE
INDICATOR
LIGHT (LED)
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it at least 6 hours prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to fully charge.
■
Charge battery pack only with the charging assembly
provided.
■
Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only.
■
Connect charging assembly to power supply.
■
Place battery pack in charging assembly. Align raised
rib on battery pack with groove in charging assembly.
See Figure 2
.
■
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charg-
ing assembly. When properly connected, red light will
turn on and remain on until battery is removed or
charger is unplugged.
WARNING:
If any parts are missing, do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
FEATURES
■
After normal usage, 3 hours of charging time is
required to be fully charged. A minimum charge time
of 6 hours is required to recharge a completely
discharged battery.
■
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
■
DO NOT place charging assembly in an area of
extreme heat or cold. It will work best at temperatures
between 50
° F–100 ° F.
OPERATION
Fig. 1
SWITCH
TRIGGER
BIT
STORAGE
CHARGER
ASSEMBLY
KEYLESS
CHUCK
TORQUE
ADJUSTMENT RING
DIRECTION OF
ROTATION SELECTOR
(FORWARD / REVERSE)
BATTERY PACK