INS_NWKBB200_REV– 06/10/13 PAGE 8
INSTALLATION AND OPERATION MANUAL
NWKBB200
TECH SUPPORT: 1.888.678.9427
Battery Configuration
One the DIN Rail has been installed and the enclosure has been mounted, setup the batteries.
We provide four 12VDC batteries that will need to be configured in series since our controller will
output 48VDC.
Batteries in Series:
Connect the unterminated end of the Negative wire to port 3 on the controller
Connect the unterminated end of the Positive wire to port 4 on the controller
Note: The controller will not power on till AC power source is detected.
To start the controller on battery power you will need to connect an RTCONN Cable to a switch to
jump start it. Cable is not provided.
