Comnet CNGE11FX3TX8MS, Инструкция по установке и эксплуатации

Страница: 252 / 314

INS_CNGE11FX3TX8MS[POE][HO] Rev. 11.6.17 PAGE 252
INSTRUCTION MANUAL CNGE11FX3TX8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Display and Save Configuration to Flash
The current configuration of the device can be displayed in the form of a virtual file containing
the full set of commands necessary to create an identical configuration. A few exceptions exist
because certain items are not displayed, such as private SSH keys. This file is called running-config
and is volatile by nature; it does not survive across reboots. It is therefore necessary to save the file
to flash storage under the name startup-config, as this file is read and executed upon every boot
and is therefore responsible for restoring the running configuration of the system to the state it
had when the save took place.
The command show running-config will display the configuration settings as seen below. For
brevity, some details were edited out. In addition, the set of interfaces is dependent on hardware
capabilities.
my-device# show running-config
Building configuration...
hostname my-device
username admin privilege 15 password encrypted
3ad61dc090116a16a7cc9861485e60e6407c5a328015b1985b585ab353c37a4441e034172401
528229795a5c9529dfbc04c86e01
!
vlan 1,42
!
spanning-tree mst name 00-01-c1-00-ad-80 revision 0
! [...]
!
interface GigabitEthernet 1/1
!
interface GigabitEthernet 1/2
!
! [...]
!
interface 2.5GigabitEthernet 1/1
!