WET X Installation and Operation Manual
Page 7
InSTallaTIOn
bEFORE yOu STaRT
q
Read all instructions and gather tools necessary before
starting the installation. Please read all safety instructions
and warnings regarding rigging and installation of the
loudspeaker. The "
q
" preceding each step can be used to
check off each step as it is completed (or applicable).
Every effort has been made to ensure that the information
contained in this manual was complete and accurate at
the time of printing. However, due to ongoing technical
advances, changes or modifications may have occurred
that are not covered in this publication. The latest version of
this manual is always available at www.communitypro.com.
The revision date can be found on the rear cover.
MOunT ThE lOudSpEakER bRackET
The WET X 12-inch and 15-inch loudspeakers are loaded
and shipped with the components in a horizontal orientation.
Attach the bracket to the support structure prior to mounting
the loudspeaker enclosure.
q
Determine the bracket location and mount the bracket to
the support structure. Mounting hardware is not included
and should be specified by a structural engineer.
q
Mount the bracket with the slot oriented correctly (where
the front of the loudspeaker will be) for later installation of
the bolt to secure the angle. [Bracket above - slot forward,
Bracket behind - slot down]. See
Figure 1
.
Note: The loudspeaker is primarily designed to be mounted
horizontally, but can be mounted vertically if desired. Please
consult a structural engineer for the appropriate mounting
mechanism and hardware. [Additional hang points on the
cabinet are available as a configure-to-order option].
MOunT ThE lOudSpEakER
q
The standard orientation of the loudspeaker is with the
horn on the right side. See
Figure 2
. If it is necessary for
coverage purposes for the horn to be on the left side, the
grille should be removed, rotated 180°, and reattached
so that the Community logo is at the bottom. There are a
number of screws around the perimeter of the enclosure,
remove them, lift the grille off, rotate it, then replace it and
reattach using all of the screws. All holes must be filled with
the original hardware (or similar approved by Community)
for the enclosure to retain its weather-resistant properties.
Figure 2.
Standard horn location (right side)
with logo at bottom of grille
Angle Securing Bolt
Rigging Bolt
Bracket
Bracket Slot
Enclosure
Bracket
Rigging Bolt
Bracket Slot
(angles marked)
Enclosure
Figure 1.
Orient the slot before mounting the bracket
