Community WET Series II, Руководство по эксплуатации и установке

Страница: 30 / 40

Community WET Series II - Operation and Installation Manual - Page 30
SSY25KIT Assembly Instructions
1. First, remove the two ½” hex head bolts located towards the front of the enclosure on both of the two end
panels (four total).
2. Next, attach one adapter plate to each end panel of the enclosure using the two ½-13 hex head bolts fitted
with lock washers and flat washers. Make sure to install a large rubber washer between the adapter plate and
the enclosure. Tighten these bolts to 15 foot-lbs using a torque wrench. Do not over tighten!
3. Now, attach the yoke to the mounting surface. No hardware is provided for this purpose. Such hardware
must be supplied by the installer, and should be rated for the weight load of the enclosure. The installer is
solely responsible for determining if the hardware used to mount the yoke is adequately sized and rated, and if
the structure it is attached to is capable of safely supporting the weight load of the enclosure and bracket.
4. After attaching the yoke to the mounting surface, next attach the yoke to the two adapter plates on the
loudspeaker enclosure using the two ½”-13 x 1.25” hex head bolts provided. Fit each hex head bolt with a flat
washer and lock washer. Tighten the fasteners until snug. After focusing the loudspeaker in the desired
position, the bolts should be tightened to a torque of 12 to 15 foot-lbs, using a torque wrench. Do not over
tighten!
Note that a series of holes are provided in the yoke bracket, allowing the enclosure to be positioned at varying
distances from the mounting surface. The closer the yoke is to the rear of the enclosure, the neater the
installation will look; the farther away the rear of the enclosure is from the yoke, the greater the available range
of motion will be.
CAUTION: Installation of loudspeakers should only be performed by trained and qualified personnel. It is
strongly recommended that a licensed and certified professional structural engineer approve the
mounting design.