Distributed Design Series Installation and Operation Manual
Page 9
Surface Mount Loudspeakers
Infin-A-Ball bracket
IP56 Cover
8. Insert the 2-pole male Euroblock connector
that is pre-wired to the
Infin-A-Ball
bracket into
the mating female connector on the back of the
loudspeaker cabinet.
9. Then press the IP56 protective cover into
place to weather seal the connection. No tool
is needed for the cover; just snap it in place.
Male Euroblock
Safety cable attachment loop
Note:
All electrical and mechanical installation connections for loudspeaker lines
are subject to all applicable governmental building and fire codes. The selection of
appropriate electrical and mounting hardware to interface with Distributed Design Series
Surface Mount Loudspeakers lies solely with the installation professional. Community
recommends that an appropriately licensed engineer, electrician, or other professional
identify and select the appropriate conduit, fittings, wire, etc. for the installation.
10. A safety cable attachment loop is built into
the rear of the loudspeaker cabinet as shown
here. You can use this to attach a suitable safety
cable as may be required by local building
and safety codes or in accordance with best
installation practices.