COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-E, Инструкция по установке и эксплуатации

Страница: 8 / 30

- 8 -
OK/ LOW IMPUT VOLTAGE LEDs: D
These two LEDs indicate the following:
The Green LED indicates the input voltage 8.6 or greater. If battery power option is used, the
ICRI will have approximately 24 hours of run time at full duty cycle.
The red LED indicates the input voltage is 7.5 to 8.5 volts. Once this light is illuminated the
ICRI will have approximately 2 hours of run time.
Note: If neither LED is lit, the ICRI will operate on voltage as low as 6.5V. Maximum input
voltage is 31VDC
BATTERY COMPARTMENT (See Section 3.0): E
EXTERNAL PELICAN CASE:
FIGURE 4: EXTERNAL ICRI
TALK GROUP SWITCH (HANDSET/HEADSET): F
The talk group switches determine which communications devices will be connected/interoperate
each other. Only the radios, telephone, or handset connected to a specific talk group will hear or be
able to transmit audio to the other individuals connected to that talk group. The switch corresponds
to the interface jacks below it. Radios/interfaces DO NOT need to be turned off or disconnected to
switch talk groups.
LEFT: Talk Group 1
CENTER: Not connected to either talk group
RIGHT: Talk Group 2
VOLUME ADJUSTMENT (HANDSET/HEADSET) G
Volume knob only adjusts the volume output level at a handset or headset connected to the ICRI at
―Handset Interface‖ jack.
To adjust the volume of the radios, use the volume adjustment on the
individual radios.