7900 Pager Programming
Manual
Page
8
©
Commtech
Wireless
5.
Run the setup file on the CDROM disk to install the software.
6.
Once it has finished installing a new menu will be created on the
Start Menu
.
Click the link and the software will start up with the
Main Screen
displayed as
seen below.
7.
The bottom window will show a list of USB programmers that are attached to
the PC. In the example above, a 7900 programming jig is connected to the PC.
NOTE: More than one USB programmer can be connected to the PC at a time!
8.
Click the USB programmer you wish to use. The drop down box below should
automatically jump to the corresponding pager type. If not choose 7900 here
and then click the
Configure
button.
9.
A new window will then be displayed showing all of the 7900 pagers settings.
From here you can edit the settings, read/write settings from/to a pager or
read/write settings from/to a file on the PC for future reference. Settings can
also be printed if you need to keep a hard copy.
10.
Whenever you wish to read or write from/to a pager, you will need to remove
the rubber grommet protecting the programming pins.
