www.commscope.com
860610260
Instruction Sheet
Page 5 of 5
Step 4
– Connect Power Source to imPower and Controller
Note:
imPower
connections will replace existing power connections for installed
imVision
controllers. Remove
installed power cord from the PWR1 port on controller.
1. Plug the other end of the power jumper cable into the
imVision
controller power input, PWR 1. See diagram
on preceeding page.
2. Connect the provided power supply cord into the P1 power jack on the rear of the i
mPower
and
turn the connector so the cable is oriented in the down position to ensure that the cable is secured.
Note:
Hold power connector at a 90° angle to the module,
push to seat connector, then turn the connector so the
cable is oriented in the down position. Ensure that the
cable is secured behind extended tab at back of housing
as shown.
3. Select and install the appropriate power supply adapter
into plug base unit, then plug unit into an approved power
outlet.
Note:
A redundant power supply connection (P2) is provided
in case that option is required. Power supply must be ordered
separately.
Step 5
– Power Up Controller
1. Please go to the
CommScope
eCatalog to download the
SYSTIMAX imVision
Controller Installation Guide
(860526839).
2. Power up
imPower
and
imVision
controller and configure settings and panels as described in the
installation guide.
O UT
B
imPower
P2
P1
Power
OUT
PWR1
Controller
Power jumper cable
Power supply
to power outlet
Optional redundant
power connection
To panel bus
Extended
tab
Rotate cable end
90° after seating
Extended
tab
imPower
