B
Figure 2
Figure 3
6. Place the box directly below the applicator. The
box can be laid down or raised off the ground by
running a lacing cord or wire through the rewind
slot of the box. Position the box in a manner that
will allow the connector carrier strip to feed
vertically into the applicator. Feed the first
connector STRAIGHT into the strip guide as far as
it will go. See Figure 4.
7. Turn the feed knob
counterclockwise one full
turn. See Figure 4.
8. Release the upper clamp handle, and place the
applicator in a horizontal position.
9. Cycle the applicator until the first connector
aligns with the top anvil as shown in Figure 5.
10. After use, using a straight instrument, turn the
rewind slot to reel the exposed connectors back
into the box.
Figure 4
Figure 5
Revisions to this instruction sheet include:
Updated document to corporate requirements
Removed obsolete applicators and connectors
Rebranded to CommScope
© 2017 CommScope, Inc.
All Rights Reserved
