CommScope FOSC-450-BS, Инструкция по установке

Страница: 14 / 16

14
8.1 Place the hook and loop fastener over the trays and basket,
place the hook and loop fastener eye on top of the trays.
8.2 Slide the base back over the Gel block and insert the frame
into the base (check proper position).
8.3 Tighten the trigger until it butts. If necessary, use wrench
(n° 12) to tighten the trigger.
8.4 Place the dome. At the end turn the dome until it fits. Use the
clamp to seal dome and base.
9 Important steps
• Before starting, slide the base over the cables.
• Routing from the basket to the trays, always from one side to the
other side.
• Avoid in all cases crossing of fibers and loose tubes.
• Replace the silica gel after each re-entry.
• Do not mount the closure with the base pointing up.
8 Closing the closure